The CAME-Mini 2 is a completely tool-less 32-bit 3-axis gimbal with dual IMU sensors that can hold camera setups that are no more than 1kg(roughly, 2.2 pounds). It's powered by four rechargeable 18650 batteries that are placed in the horizontal cross bar of the Mini 2. A new "Stop Ring" has beed added to the Mini 2, preventing the roll motor from over rotating, which may cause the internal wires to become tangled.
Initially, you can download any version of the SimpleBGC software to connect to your gimbal. After your first successful connection, look at the version of the firmware on the screen (shown in green below).
Once you have verified the firmware version, you can go back and download the correct GUI version to match your firmware.
Typically, you will want the the software version whose number is equal or lower than the firmware version. For example, in the example above, since your gimbal has been programmed with a 2.56 b9 firmware, you will want to find a SimpleBGC software version that is equal or slightly lower than 2.56 b9. In this case, the closest software version available is 2.56 b7. You should always use the same GUI when configuring your gimbal. And most importantly, NEVER upgrade your firmware!!!
Download link for the SimpleBGC GUI software can be found here.
All CAME-TV gimbals have been designed to support numerous camera/lens setups. That is, as long as the overall payload does not exceed that particular gimbal's pre-determined weight capacity. However, it is also possible for a camera setup to be too light. When this happens, users may notice shaking, vibrating, and even noises coming from the motor of their gimbal. But don't panic!! Essentially, the gimbal's motors have been programmed to expect a slightly heavier payload and are just working a little bit harder than they have to.
A quick fix to this problem, would be simply to lower the Motor Power in the SimpleBGC software. But first, before making any changes, we advise archiving all of your current settings (ex: saving your profile or capturing screenshots). In the unlikely event that you may have to revert back to those values, you'll at least have your screenshots for reference. Once that's done, investigate the gimbal and find out which motor (Yaw, Pitch, or Roll) is giving you problems. Once you have determined the culprit, connect to the software and reduce the Motor Power settings accordingly. Step by step details can be found in the video below.
NOTE: For heavier camera setups, simply increase motor power settings instead of decreasing them.
During this motor power adjustment process, it is ok to turn on your gimbal and test functionality after applying changes. Please know that this is a trial & error process and it may take some time to find the perfect settings for your camera setup. And just as a reminder, once you're able to determine the correct settings in one profile to stabilize your gimbal, apply those settings to the remaining 2 profiles in the Basic Tab of the software.
This video by MrCheesycam should only be used as a reference for restoring your the default configuration found on the CAME-TV CAME-MINI2 Gimbal using firmware 2.43 b9.
While you can use the video as reference to copy the settings exactly, there are a few areas in which you DO NOT want to change on your system. This video will explain which options you should copy, and which settings you should NOT COPY.
Do not change your default RC Trim Settings according to the settings in the video above. If you believe you need to make changes to your RC Trim Settings, you can view our FAQ Article about Gimbal RC Settings.